KWS Engineering SA Information

Established in 2011, we are professional in design, engineering, making injection thermoplastic, compression, reaction molds. Around 95% of our moulds are exported to Europe, USA and Russia. With over 85% are from automotive industry, we made lots of interior trim and exterior trims parts, such as Instruction Panel, steering wheel, frog lamp reflector, Grille, we also earned lots of experience in making some typical products such as automotive ip, door panel, front bumper, rear bumper as well as mesh components. OUR SERVICES •Co-design •Analysis of flow and cooling •Programming tools •Quality control and 3D measurement of each component •Assistance during the start-up •Expertise •Mold-flow analysis and structural calculation •Adoption of advanced optimization engineering •Supplies and equipment lines •Technical advice •Analysis aimed at reducing weight and optimizing the production cycle CONTACTS Swiss Office KWS engineering SA Via Laveggio n° 3 CH-6855 Stabio Russian Office 445057 Tolyatti – Russia Complex Vega, Uliza Jebileina, 40 Phone 0041 (0) 91 9931090 Fax 0041 (0) 91 9931092 automotive@kws-eng.ch www.kws-eng.ch